VEGA VEGAPULS 66 Antenna extension - Manual (Page 8)

5 Tighten screws crosswise, torque max. 2.5 Nm (1.844 lbf ft)
Mounting is finished.
3.4 M ounting steps, multi-sectional antenna
extension
With multi-sectional antenna extensions, the antenna system consists
of upper section, middle section and antenna. The parts are shipped
unassembled. When mounting, all parts must be assembled according
to the markings on the flanges.
Proceed as follows:
1 Remove conical protective cover from radar sensor
2 Assemble radar sensor and individual parts of the antenna
extension in such a way that the respective markings for the
polarisation plane are aligned with each other.
1
Fig. 5: Position of the polarisation markings
1
Markings for the polarisation plane
3 Fasten the individual parts with the supplied screws, starting with
the antenna and ending with the upper part
4 Make sure that all parts are assembled gap free
5 Tighten screws crosswise, torque max. 2.5 Nm (1.844 lbf ft)
8 Antenna extension • for VEGAPULS 66
3 Mounting
34195
-EN
-090130