VEGA VEGABOX 02 - Manual (Page 12)

1 Snap VEGABOX 02 onto the carrier rail or screw it to the mounting
plate
2 Loosen the cover screws and remove the cover
3 Insert the sensor cable into VEGABOX 02 through the cable entry
4 Loosen the screws with a screwdriver
5 Insert the wire ends into the open terminals according to the wiring
plan
6 Tighten the screws with a screwdriver
7 Check the hold of the wires in the terminals by lightly pulling on
them
8 Tighten the compression nut of the cable entry. The seal ring must
completely encircle the cable
9 Connect the supply cable according to steps 3 to 8
10 Screw the housing cover back on
The electrical connection is hence finished.
5 .3 Wiring plan
1
2
–
+
1
2
3
4
5
6
1
2
3
4
5
6
Fig. 3: Terminal assignment VEGABOX 02
1 To power supply or the processing system
2 Shielding 1 )
Wire number Wire colour/Polarity VEGABOX 02 terminal
1 brown (+) 1
2 blue (-) 2
1) Connect screen to ground terminal. Connect ground terminal on the outside
of the housing as prescribed. The two terminals are galvanically connected.
VEGAWELL 52 -, 72 - 4 …
20
mA
12 VEGABOX 02
5 Connecting to power supply
32798
-EN
-120820