VEGA VEGACAL series 60 - Manual (Page 8)

4 Loosen the two holding screws with a screwdriver (Torx size T 10
or Phillips size 4)
2
1
Fig. 3: Loosening the holding screws
1 Electronics module
2 Screws (2 pcs.)
5 Pull the previous electronics out by holding the opening levers.
6 Insert the new electronics module carefully.
7 Insert the two hold screws and tighten them
8 Connect the connection cables according to the operating
instructions manual of the respective sensor
9 Screw the housing cover on
The electronics exchange is now finished.
As a rule, an exchange of electronics must be documented internally
when Ex applications are involved.
8 Electronics module • VEGACAL series 60
4 Mounting
30531
-EN
-110411