VEGA VEGAWAVE 62 - NAMUR - Manual (Page 9)

3 .3 Operation
With the factory setting, products with a density of > 0.02 g/cm³
(0.0008 lbs/in³) can be measured. The instrument can also be adapted
to products with lower density > 0.008 g/cm³ (0.0003 lbs/in³).
On the electronics module you will find the following indicating and
adjustment elements:
l Signal lamp for indication of the switching condition (yellow)
l Potentiometer for adaptation to the product density
l Mode switch to select the switching condition (reverse character-
istics)
l Simulation key
3 .4 Storage and transport
Your instrument was protected by packaging during transport. Its
capacity to handle normal loads during transport is assured by a test
according to DIN EN 24180.
The packaging of standard instruments consists of environment-
friendly, recyclable cardboard. In addition, the sensor is provided with
a protective cover of cardboard. For special versions PE foam or PE
foil is also used. Dispose of the packaging material via specialised
recycling companies.
Transport must be carried out under consideration of the notes on the
transport packaging. Nonobservance of these instructions can cause
damage to the device.
The delivery must be checked for completeness and possible transit
damage immediately at receipt. Ascertained transit damage or
concealed defects must be appropriately dealt with.
Up to the time of installation, the packages must be left closed and
stored according to the orientation and storage markings on the
outside.
Unless otherwise indicated, the packages must be stored only under
the following conditions:
l Not in the open
l Dry and dust free
l Not exposed to corrosive media
l Protected against solar radiation
l Avoiding mechanical shock and vibration
l Storage and transport temperature see chapter "Supplement -
Technical data - Ambient conditions"
l Relative humidity 20 … 85 %
Packaging
Transport
Transport inspection
Storage
Storage and transport
temperature
VEGAWAVE 62 • - NAMUR 9
3 Product description
32254
-
EN
-120418