VEGA VEGASON 61 4 … 20 mA_HART - two-wire - Manual (Page 33)

33
6 Set up with the display and adjustment module PLICSCOM
VEGASON 61 • 4 … 20 mA/HART - two-wire
28775-EN-130417
Service
Basic adjustment 4
Display
Diagnostics
▶ Service
Info
False signal suppression 4.1
Change now?
Extended setting 4.2
None
▼
Current output 4.3
Characteristic: 4-20 mA
▼
Fail.mode: < 3.6 mA
▼
Min. current: 3.8 mA
▼
Simulation 4.4
Start simulation?
Reset 4.5
Select reset?
Unit of measurement 4.6
m(d)
▼
select?
Language 4.7
Deutsch
▼
SIL 4.8
Not activated
▼
HART mode 4.9
Standard
Address 0
Copy sensor data 4.10
Copy sensor data?
PIN 4.11
Enable?
Info
Basic adjustment 5
Display
Diagnostics
Service
▶ Info
Instrument version 5.1
Serial number
12345678
Date of manufacture 5.2
21. January 2009
Software version
3.50
Last change using PC 5.3
21. January 2009
Sensor characteristics 5.4
Display now?
6.10 Saving the parameter adjustment data
We recommended noting the adjusted data, e.g. in this operating
instructions manual, and archiving them afterwards. They are thus
available for multiple use or service purposes.
If VEGASON 61 is equipped with a display and adjustment module,
the most important data can be read out of the sensor into the display
and adjustment module. The procedure is described in the operating
instructions manual "Display and adjustment module" in the menu
item "Copy sensor data". The data remain there permanently even if
the sensor power supply fails.
If it is necessary to exchange the sensor, the display and adjustment
module is inserted into the replacement instrument and the data are
written into the sensor under the menu item "Copy sensor data".