ARIETE Hot Aqua Power 2479 - Manual (Page 22)

WARNING: Only use the hand grip (10) to lift or carry the appliance. The appliance must always be
switched off before it can be carried.
- Fit the required attachment onto the grip of the suction hose (A) according to the type of cleaning
required and the surface to be cleaned (Fig. 5). Insert the attachment and lock it into place by
turning the relevant tab (Fig. 6).
WARNING: Before using the appliance, make sure that all filters have been fitted into the correct
position (see “Cleaning and Maintenance”).
- Pull out the power cord and plug the appliance into the power mains socket.
- Press the on/off switch (1) with your foot to switch on the appliance (Fig. ).
Appliance suction will start. It is possible to adjust suction power using the special dial (1) on
the top of the appliance (Fig. ), or by opening the valve (A) on the hand grip of the suction hose
(Fig. 9).
- If you decide to use the suction function together with the wash function using hot water and
cleaning agent, you must first start the pump by pressing the on/off switch for the pump to
dispense cold water (0) and at the same time, the hot water button () on the top of the appli--
ance. The indicator lights will switch on and stay lit for the whole time that the pump is operat--
ing.
WARNING: Before washing and dispensing cleaning agent, it is recommended that you test a small
concealed area of the surface to be treated, according to its type.
- Dose the amounts of cleaning agent to be dispensed by pressing the dispensing button (A) on
the handgrip of the “Push & Clean” attachment. Make sure that the pump indicator light (0) is
switched on (Fig. 10).
- After dispensing the required amount of cleaning agent and hot or cold water onto the surface,
switch off the dispensing pump by pressing the two switches; wait a few minutes for the clean--
ing agent to act, start the suction function to remove the dirt by pressing on/off button (1) as
already illustrated (Fig. ) and move the hose attachment in a backward direction.
- Dispense the cleaning agent and move the hose slowly backwards across the surface being
cleaned. The mix sprayed by the appliance will be cleaned up immediately, along with any dirt.
WARNING: Never place the appliance in an upright position when it is being used to clean up water
or to dispense cleaning agent.
- If the suction power should diminish during use, this means that it is necessary to remove the
dirt from the tank.
- After cleaning, switch off the appliance using the on/off switch (1) and switch off the water
dispensing pump with the relevant switch (0).
Unplug the appliance from the mains power and rewind the power cord automatically inside the
appliance by pressing the relevant button with your foot (16) (Fig. 11).
- Put away the appliance; it is possible to lock the tubes (L) into place with the special attachment
on the back of the vacuum cleaner (Fig. 1).
- Put away the cleaning agent attachment.
GB
- 0 -