VEGA VEGAVIB 65 - contactless electronic switch - Manual (Page 19)

6 Set up
6.1 General
The numbers in brackets refer to the following illustrations.
On the electronics module you will find the following indicating
and adjustment elements:
l
Potentiometer for switching point adaptation (1)
l
DIL switch for mode adjustment - min./max. (2)
l
Signal lamp (5)
Note:
As a rule, always set the mode with mode switch (2) before
starting the setup of VEGAVIB 65 . The switching output will
change if you set the mode switch (2) afterwards. This could
possibly trigger other connected instruments or devices.
6.2 Adjustment elements
3
4
5
1
2
Fig. 11: Oscillator VB60C - Contactless electronic switch
1 Potentiometer for switching point adaptation
2 DIL switch for mode adjustment
3 Ground terminal
4 Screwed terminals
5 Control lamp
Function/Configuration
VEGAVIB 65 - with contactless electronic switch 19
Set up
29284
-EN
-060508