VEGA VEGACAP 66 - transistor (NPN_PNP) - Manual (Page 22)

22
6 Setup
VEGACAP 66 • - transistor (NPN/PNP)
30022-EN-130916
5. Turn the potentiometer (1) very slowly clockwise until the control
lamp (6) lights red. If the control lamp does not light red, set the
meas. range selection switch (2) to the next higher stage and
repeat the setting with the potentiometer (1) until the control lamp
lights red.
The measuring system is now ready for operation.
6.3 Function chart
The following chart provides an overview of the switching conditions
depending on the set mode and the level.
Level Switching status Control lamp
Mode max.
Overflow protec-
tion
closed
Green
Mode max.
Overflow protec-
tion
open
Red
Mode min.
Dry run protection closed
Green
Mode min.
Dry run protection open
Red
Failure of the sup-
ply voltage
(min./max. mode)
any open
Fault any open
flashes red