VEGA VEGACAL 63 Profibus PA - Manual (Page 46)

46
10 Supplement
VEGACAL 63 • Profibus PA
30028-EN-130917
Status
code
Description according to
Profibus standard
Possible cause
0x44 uncertain - last unstable value Failsafe replacement value (Failsafe-Mode = "Last value" and al-
ready valid measured value since switching on)
0x48 uncertain substitute set – Switch on simulation
– Failsafe replacement value (Failsafe-Mode = "Fsafe value")
0x4c uncertain - initial value Failsafe replacement value (Failsafe-Mode = "Last valid value" and
no valid measured value since switching on)
0x51 uncertain - sensor; conversion
not accurate - low limited
Sensor value < lower limit
0x52 uncertain - sensor; conversion
not accurate - high limited
Sensor value > upper limit
0x80 good (non-cascade) - OK OK
0x84 good (non-cascade) - active
block alarm
Static revision (FB, TB) changed (10 sec. active, after the parame-
ter of the static category has been written)
0x89 good (non-cascade) - active ad-
visory alarm - low limited
Lo-Alarm
0x8a good (non-cascade) - active ad-
visory alarm - high limited
Hi-Alarm
0x8d good (non-cascade) - active crit-
ical alarm - low limited
Lo-Lo-Alarm
0x8e good (non-cascade) - active crit-
ical alarm - high limited
Hi-Hi-Alarm