VEGA VEGADIS 50 Ex - Manual (Page 7)

VEGADIS 50 7
Set-up
• Loosen the four screws on the upper side
of VEGADIS 50 and remove the housing
cover with the integral indicating module.
You can facilitate the connection and the
adjustment of VEGADIS 50 by fastening
the housing cover by means of two screws
laterally or displaced to the bottom.
• The adjustment of the 6-key adjustment
module is stated in the operating instruc-
tion of the appropriately connected sensor.
• It has proven in practice to mark
VEGADIS. Information on the appropriate
measurement loop and the appropriate unit
of the indicated value help to avoid failures
and misunderstandings. A gap is provided
on the housing cover for marking. You can
glue in a label (48 x 11 mm) and mark it
appropriately. Example for such a label:
Litre
Meas. loop: F 37
Tank 14
Cleaning solvent
4.2 Adjustment structure
Series 50 sensors can be adjusted
- with the PC (adjustment program VVO)
- with the detachable adjustment module
MINICOM
- with the HART ® -handheld.
The adjustment must always be made with
only one adjustment medium. It is not possi-
ble to make the parameter adjustment at the
same time with the MINICOM and the HART
® -
handheld.
Adjustment module MINICOM
With the adjustment module MINICOM you
adjust in the sensor or in the external indicat-
ing instrument VEGADIS 50. The adjustment
module enables via text display with 6-key
field the adjustment like with the adjustment
program VVO.
- +
Tank 1
m (d)
12.345
Screws
Adjustment
module
- + ESC
OK
2
4
Tank 1
m (d)
12.345
- + ESC
OK
Tank 1
m (d)
12.345
4 ... 20 mA
• Place the housing cover (3) again to the
housing (1) and tighten the four screws on
the upper side of the instrument.