VEGA VEGADIS 10 - Manual (Page 7)

VEGADIS 10 7
Instrument modification
5 Instrument modification
5.1 Exchange of adjustment
modules
Removal of an adjustment module
1
Separate VEGABAR from voltage supply
(if VEGADIS 10 i s already connected to
VEGABAR)
2 Loosen screws on cover of VEGADIS 10
3 Loosen connection cable from the te rmi-
nals
4 Loosen screws of the adjustment module
5 Detach the adjustment module and re-
move the plug connection
Addition of an adjustment module
6
Plug the plug connection of the new ad-
justment module to the plug-in socket
7 Screw on the new adjustment module
8 Connect the connection cables to termi-
nals
9 Close cover of VEGADIS 10
10 If necessar y, reconnect VEGABAR to
voltage supply
Indicating modules
Retrofitting of an indicating module
1
Separate VEGABAR from voltage supply
(if VEGADIS 10 i s already connected to
VEGABAR)
2 Loosen the screws on the cover of
VEGADIS 10
3 Remove cover
4 Connect indicating module to the screw
terminals via the four cables (see "3.2
Connection plan“)
Note:
Step 4 will be easier if the indicating module
is temporarily loosely fastened (displaced)
using two screws.
5 Place the indicating module on VEGADIS
10 in the correct position
6 Tighten the screws of the cover
7 If nec essary, reconnect VEGA BAR to
voltage supply
Indicating
module with
LC display
VEGADIS 10
Module without
adjustment Module for
menu-guided
adjustment Module for
basic
functions
Adjustment modules
The modular construction of VEGADIS 10
ensures that adjustment modules a nd the
indicating module can be retrofitted, ex-
changed or removed.
The connection of the modules is made:
- on the adjustment module via 4-pole plug
connection
- on the indicating module via screw termi-
nals.