Doorbell location testing – VTech IS741 Manual User Manual
Page 5

5
Before mounting the doorbell on a wall, make sure you test if
the location you install the doorbell is in range, and adjust the
camera angle to best suit your needs.
You may unplug the AC power first so that you can move around
more conveniently to make the tests.
To test the location for installation:
Hold the doorbell in the location where you want to install the
doorbell, then follow the steps below to test the reception range
and video capture angle.
Press
MENU
>> Press q or p to
Settings >> Press
SELECT
.
Press q or p to
Doorbell setup >> Press
SELECT
.
Press
/DOORBELL to check the video streaming quality.
The handset displays
The handset is muted during the
setup mode, then press
OK
.
Press , then press
+
or
-
to adjust the video
streaming brightness.
If audio feedback occurs, press on the handset to turn off
the speakerphone.
If the desired location is in good range, the handset
displays .
If the desired location is not in good range, the handset
flashes in red. Press
INFO
for instructions to relocate your
handset and/or telephone base. When the reception is in
good range, the handset displays . Press
OK
to return to
the video streaming.
6. Keep the video streaming on for camera lens adjustment.
When you check for the desirable location to install the doorbell:
Make sure the visitor is standing in a reasonable distance
away from the doorbell.
Avoid mounting it to where it is exposed to direct sunlight.
Avoid mounting it to where reflections may be caused by
sunlight, for example, opposite to a white wall.
1.
2.
3.
4.
5.
•
•
•
•
•
•
4
Doorbell location testing
8
inches
50 degrees
63 inches
0
inches
Shooting area