Add and register a handset, Deregister handsets, Battery charging – VTech LS6001_-13-15-16-17 Manual User Manual
Page 3

3
Add and register a handset
You can add new handsets (
LS6001/LS6001-13/LS6001-15/LS6001-16/LS6001-17,
purchased seperately) to your telephone system. Each handset must be registered
with the telephone base before use. When first purchased and properly charged,
each expansion handset alternately displays
To register HS... and ...see manual.
The new handset should be charged without interruption for at least 30 minutes
before registering it to the telephone base.
To register a handset:
At the bottom of the telephone base, press and hold
/
FIND HANDSET for about four seconds until it
shows
Registering...
On the cordless handset, press then it
shows
Registering... Both the telephone base
and cordless handset show
Registered and
you hear a beep when the registration process
completes. The registration process takes about
60 seconds to complete.
Deregister handsets
If you want to replace a handset or reassign the designated handset number of
a registered handset, you must deregister all handsets and then deregister each
handset individually.
To deregister all handsets:
Press and hold
/FIND HANDSET at the bottom of the telephone base for about
0 seconds until the telephone base shows
Registering... then De-register?
Immediately press
/FIND HANDSET again. You hear a confirmation tone.
All handsets alternately show
To register HS... and ...see manual. The
deregistration process takes about 0 seconds to complete.
.
.
.
.
3.
Battery charging
Once you have installed the battery, the screen indicates the battery status
(see the table below). For best performance, keep the handset in the telephone
base or charger when not in use. The battery is fully charged after hours of
continuous charging.
Battery indicators
Battery status
Action
The screen is blank, or
displays
Put in charger
and flashes.
The battery has no or very
little charge. The handset
cannot be used.
Charge without interruption
(at least 30 minutes).
The screen displays
Low battery and flashes.
The battery has enough
charge to be used for a
short time.
Charge without interruption
(about 30 minutes).
The screen displays
HANDSET X.
The battery is charged.
To keep the battery charged,
place it in the telephone base
or charger when not in use.