VTech CS6429-5 Abridged manual - Manual (Page 3)

3
Tabletop to wall mount installation
The telephone comes ready for tabletop use. Follow the steps below to mount your
telephone on a wall.
Route the telephone line cord
through the hole on the wall mount
bracket and plug it into the telephone
wall jack. Route the power cord out
of the telephone base and plug it into
an electrical outlet not controlled by a
wall switch.
3. Align the holes on the bracket with
the standard wall plate and slide the
bracket down until it locks securely.
Bundle the telephone line cord
and power adapter cord neatly
with twist ties.
4.
Position the telephone base against
the wall mount bracket as shown.
Insert the extended tabs marked B
on the wall mount bracket into the
slots marked B on the back of the
telephone base. Push the telephone
base down until it clicks securely.
2. Plug one end of the telephone line
cord into the TEL LINE jack at the
bottom of the telephone base and
the base power adapter into the
POWER jack.
.
Battery charging
Once you have installed the battery, the screen indicates the battery status (see
the table below). For best performance, keep the handset in the telephone base or
charger when not in use. The battery is fully charged after 0 hours of continuous
charging. Refer to the online user’s manual for battery operating times.
If you place the handset in the telephone base or charger without plugging in the
battery, the screen displays NO BATTERY.
•
Battery indicators Battery status Action
The screen is blank,
or shows PLACE IN
CHARGER and flashes.
The battery has no charge
or very little charge. The
handset cannot be used.
Charge without interruption
(at least 30 minutes).
The screen shows
LOW BATTERY and
flashes.
The battery has enough
charge to be used for a
short time.
Charge without interruption
(at least 30 minutes).
The screen shows
HANDSET X.
The battery is charged. To keep the battery
charged, place it in the
telephone base or charger
when not in use.
Telephone base overview
X/DELETE
Delete the playing
message.
Press twice to delete
all previously reviewed
messages when the
phone is not in use.
Message window
Shows the number of messages and other
answering system information.
IN USE light
Flashes when there is an
incoming call, or another
telephone sharing the same
line is in use.
On when the handset is in
use, or the answering system
is answering a call.
/FIND HANDSET
Press once and then release
to page all system handsets.
/SKIP
Skip to the next message.
/PLAY/STOP
Play or stop playing messages.
/ANS ON/OFF
Turn the answering system
on or off.
/REPEAT
Press to repeat a message or press
twice to play the previous message.
/VOL and /VOL
Adjust the volume during
message playback.
Adjust the telephone
base ringer volume when
the phone is not in use.