VTech LS6375-3 Manual - Manual (Page 38)

34
Telephone operation
PTT to all handsets
You can connect a PTT call from a single handset to all available
system handsets.
You have four ways to begin a PTT-to-all call:
Press and hold PUSh TO TALK when the handset is not in use.
If you have more than two handsets, press PUSh TO TALK when the
handset is not in use. Then press
TONE
.
If you have more than two handsets, press PUSh TO TALK when
the handset is not in use. Press /
VOL
or
VOL
/
CID
to highlight
>All handsets, then press
MENU
/SELECT or PUSh TO TALK.
If you have more than two handsets:
a) Press
MENU/
SELECT
when the handset is not in use.
b) Press /
VOL
or
VOL
/
CID
to highlight > Push to talk, then press
MENU
/SELECT.
c) Press /
VOL
or
VOL
/
CID
to highlight > All handsets, then press
MENU
/SELECT or PUSh TO TALK.
Your handset displays Connecting to All handsets... for a few seconds.
When the connection is made, all handsets display Press and hold [PTT]
to talk and beep once.
Press and hold
PUSh TO TALK on your handset. A chirp indicates your
microphone is on. Speak towards the handset. Your voice is broadcast to
all destination handsets.
While you are speaking, your handset displays
PTT To hANDSET X (X
represents the destination handset numbers; a maximum of four handset
numbers appear).
Release
PUSh TO TALK after speaking. All handsets beep once again.
After the handsets beep, you can press and hold PUSh TO TALK to
continue speaking or the destination handsets can respond (see Answer
PTT on page 35).
To end the PTT call, press
OFF/
CLEAR
or place the handset in the
telephone base or charger. The handset displays Push to talk Ended
for a few seconds.
1.
•
•
•
•
2.
3.
4.
After PUSh TO TALK is released, the PTT call remains open for a short
time. If no one presses PUSh TO TALK within 10 seconds, the PTT call
ends automatically.