VTech TR08-2013 Manual - Manual (Page 3)

Battery charging
Once you have installed the battery, the screen indicates the battery status
(see the table below). For best performance, keep the handset in the telephone
base or charger when not in use. The battery is fully charged after hours of
continuous charging.
Battery indicators Battery status Action
The screen is blank, or
displays Put in charger
and flashes.
The battery has no or very little
charge. The handset cannot
be used.
Charge without interruption
(at least 0 minutes).
The screen displays
Low battery and flashes.
The battery has enough charge
to be used for a short time.
Charge without interruption
(about 0 minutes).
The screen displays
HANDSET X.
The battery is charged. To keep the battery
charged, place it in the
telephone base or charger
when not in use.
If you place the handset in the telephone base or charger without plugging in the
battery, the screen displays No Battery.
Add and register a handset
This telephone system accommodates up to five handsets. Each new handset must
be registered with the telephone base before use. Additional handsets registered to
the telephone base are assigned numbers in the sequential order.
When first purchased and properly charged, each expansion handset shows
To register HS... and ...see manual alternately. Charge the handset before
registering it to the telephone base.
To register a handset:
Place the new/non-registered handset in the telephone base.
. After about 0 seconds, the handset displays Registering... When the
registration process completes, the handset displays Registered and you hear
a beep. The registration process takes about 90 seconds to complete.
Deregister handsets
If you want to replace a handset or reassign the designated handset number of a
registered handset, you must deregister all handsets and then individually register
each handset.
If you want to register a handset to another
TR1-2013/TR16-2013/TR17-2013/
TR2-2013/TR26-2013/TR27-2013 base, you must deregister all handsets, and then
individually register each handset to the desired base.
To deregister all handsets:
Press and hold / FIND HANDSET on the telephone base for about 0 seconds
until the IN USE light on the telephone base turns on and starts flashing.
Immediately press / FIND HANDSET again. You must press /FIND HANDSET
while the IN USE light is still flashing. The IN USE light flashes for approximately
five seconds.
All handsets display
To register HS... and ...see manual alternately when the
deregistration process completes. The deregistration process takes about
0 seconds to complete.
.
.
.
.
Do not place the
handset in the charger.