VTech DS6701 Manual - Manual (Page 4)

Battery
It takes up to 11 hours for the battery to be fully charged. When it is fully charged, you can expect the
following performance:
Operation Operating time
While in use (talking*) Up to 7 hours
While in speakerphone mode (talking*) Up to .5 hours
While not in use (standby**) Up to 5 days
* Operating times vary depending on your actual use and the age of the battery.
** Handset is not charging or in use.
The battery needs charging when:
A new battery is installed in the handset.
The handset beeps every 50 seconds while on a call.
The handset beeps and
Low battery displays on the handset.
Put in charger displays on the handset.
A battery is properly installed and the screen is blank.
CAUTION:
To reduce the risk of fire or injury, read and follow these instructions:
Use only the battery provided or equivalent. To order a replacement, visit our website at
www.vtechphones.com or call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or
call 1 (800) 267-7377.
Do not dispose of the battery in a fire. Check with local waste management codes for special disposal
instructions.
Do not open or mutilate the battery. Released electrolyte is corrosive and may cause burns or injury to the
eyes or skin. The electrolyte may be toxic if swallowed.
Exercise care in handling batteries in order not to create a short circuit with conductive materials.
Charge the battery provided with or identified for use with this product only in accordance with the
instructions and limitations specified in this manual.
Observe proper polarity orientation between the battery and metallic contacts.
To prevent fire or shock hazard, do not expose this product to water or any type of moisture.
•
•
•
•
•
•
•
•
•
•
•
•
Handset overview
CID/ /VOLUME
/HOME/FLASH
MUTE/DELETE
CHARGE light
Dialing keys
/ /VOLUME
MENU/SELECT
OFF/CANCEL
REDIAL/PAUSE
1
/CELL
TONE
QUIET
#