Velleman projects VMB1TC Getting started manual - Manual (Page 2)

www.velbus.be
Easy 3 Easy 3 - - step installation: step installation:

Install the relay(s) in your fuse box or other appropriate place for ease of wiring

Provide each relay with an address (write down the address), see user manual VMB4RYNO / VMB4RYLD

Connect the relay contacts with the appropriate target unit (heating, circulation pump, air-conditioning…)
2. Install the temperature 2. Install the temperature
sensors in each room sensors in each room
NOTE: Mind direct sunlight, draft and away from heating/cooling vents
 Perform next steps before final fixation of the sensor, once mounted, the config buttons
are no longer accessible, then only PC configuration is possible.
(see controller user manual)

Provide each temperature sensor with an address (write down the address), Assign (learn) the sen-
sor outputs to a relay contact
(*) for its purpose,
Examples:

 Room heater or room water valve.
 
Activated by the sensor if the room need to heat
  Central heating system
 
Activates your central heating system as soon as at least 1 sensor is set in day/or comfort temperature
  Central heating system main pump
 
Activated as soon as at least 1 sensor needs to heat a room (or if anti-pump jam is set)
  Central air-conditioning system
 
Activated by the sensor to cool down the room
  An extra fan for quick heating or cooling (Boost)
 
Activated by the sensor if target temperature must recover a big difference
  Alarm siren or light
 
Activated as soon as a temperature has reached a preset alarm temperature, separate high or low alarm is
possible

Install the controller in the room where you want to control or monitor the temperature.

Preferably install the clock battery back-up type CR2032.

Set a unique address for each controller . (see also the controller user manual).
3 3
2 2
1 1
PAGE 2
Install the controller at
eyesight level!
4- wire Velbus cable
5 4 1 0 3 2 9 4 2 1 2 0 5
(*) NOTE:
Assigning sensors to relay contacts can also
be performed using our free VELBUSLINK
software and an interface (see other side).
HVMB1TS'UK
www.velbus.be
1. Power 1. Power relays relays
3. Install the temperature 3. Install the temperature
controller(s). controller(s).