beautypg.com

Operating instructions, Fan & cooling control, Temperature control – DAEWOO ELECTRONICS DWB-126CH User Manual

Page 9: Heater lamp, Caution

background image

OPERATING INSTRUCTIONS

9

• FAN & COOLING CONTROL

The Fan Control Selector Switch has six positions.
Choose one of the speed settings by rotating the fan control Selector Switch to the appropriate position.

OFF

Select this setting for stop all operation of air conditioner

FAN

Select this setting for low speed air circulation without
cooling and heating.

LOW COOL

Select this setting for cooling operation with LOW FAN.

HIGH COOL

Select this setting for cooling operation with HIGH FAN.

LOW HEAT

Select this setting for Heating operation with LOW FAN.

HIGH HEAT

Select this setting for Heation operation with HIGH FAN.

• TEMPERATURE CONTROL

Choose a temperature settings by rotating the knob of thermostat to the appropriate position

• The Thermostat automatically starts and stops cooling operation in order to

keep the room temperature at a proper level, and this results in efficient use of
power and economical cooling.

• Turn clockwise for a cooler room temperature.
• Turn counter-clockwise for a warmer room temperature.

• HEATER LAMP

When the unit sets heating operation condition, the red lamp is lighted.
When the frost settles on the heat exchanger of the outside, defrosting is made automatically and the red
lamp is turned off.
The unit may give a hiss and the fan motor stops for 1 to 10 minutes.
This should not be regarded as a problem.
After defrosting, the heating operation begins again.

NOTE

• FOR MOST ECONOMICAL USE

1. Properly control the room temperature.
2. Avoid the unit being exposed to direct sunlight. Keep direct sunlight from the room.
3. Do not leave doors and windows open.

NOTE

Setting the control at the coldest extreme of the temperature range will not cool the room any
faster. Usually the midpoint is a good starting position. If the room temperature is not satisfactory
after a reasonable period of time, adjust the temperature control to a lower or higher setting.

WARMER

COOLER

HIGH

COOL

LOW

COOL

HIGH

HEAT

LOW

HEAT

FAN

FAN

OFF

SELECTOR

WARMER

COOLER

THERMOSTAT

CAUTION

When the air conditioner has been performing its cooling operation and is turned “OFF” or set to
the ‘FAN” position, wait at least 3 minutes before resetting to the cooling operation.