Omnimount PLAY40 Manual ru - Manual (Page 9)

PN:888-45-222-W-03 revG: 45-284-026: OM1100549
STEP 1 - Placement of Arm on the Wall
1
1. MOUNTING CONSIDERATIONS:
• Wall Mount Bracket MUST be attached to a stud or solid concrete. DO NOT attach this product to hollow wall or any other
configuration.
• Make sure Arm will have desired unobstructed range of motion: up-down, side-to-side, in-out (see section RANge Of MOTiON).
• Make sure cables will reach their destinations with enough remaining slack to allow Arm full range of motion.
• Use the RANge Of MOTiON section to familiarize yourself with the movements of this product. Take into account that the TV will
change location from Side-to-Side when pulled out from the wall.
• Use the SpAce ReqUiReMeNTS section for maximum measurements of this products full range of motion.
• if there is no available stud for desired TV location, you may want to insert horizontal studs into your wall at the desired mounting
location (see “Horizontal Studs” image below).
2. CHOOSE YOUR DESIRED TV LOCATIONS:
choose your desired TV locations when stowed and extended. Note the TV will move side-to-side when pushing it into and pulling
it out from the wall as well as lifting it up and lowering it down. This step requires an understanding of this products Range of
Motion (see section RANge Of MOTiON).
3. CHOOSE AN AVAILAbLE WALL MOUNTING LOCATION:
find an available stud or area of solid concrete to attach the
Wall Mount Bracket to that will allow your TV to be stowed
and extended as desired.
place the Template on the wall. When the Wall Mount Bracket
on the Template is lined up with the mounting location on
the wall (stud or concrete), the ‘TV ARc’ lines will show you
the available locations of the center of your TV when stowed
against the wall.
Once you’ve lined up the mounting location to a stud
or solid concrete that will place your TV in your desired
locations, use a punch to mark your wall at the 2 Mounting
Hole locations on the Template. Then remove the template
from the wall.
INSTRUCTIONS
RANGE OF MOTION
SPACE REQUIREMENTS
front
front front front
front
front
side side side
side
top
top top top
top
Horizontal Studs
Arm fully extended from Wall
full Up
full Up
full Up
in the center
in the center
in the center
full Down
full Down
full Down
Arm flat Against Wall (to the left)
Arm flat Against Wall (to the right)
Distance from the Wall
if there is no available stud for
desired TV location, you may
want to insert horizontal studs
into your wall at the desired
mounting location.
24.5” (622 mm) +
Thickness of TV
18.19” (462 mm) + Thickness
of TV
Horizontal Space Requirements
33.76” (858 mm) + Width of TV*
Vertical Space
Requirements
20” (508 mm) + Height
of TV*
*Space requirement dimensions assume mounting holes are centered on the TV.
front side top
front side top front side top
front side top front side top front side top