Ohaus NAVIGATOR NVT Quick Start Guide - Manual (Page 2)

Navigator

Balance Quick Start Guide
Navigator

Balance Quick Start Guide ii Ohaus Corporation www.ohaus.com
SAFETY PRECAUTIONS

Before plugging in the balance, verify that local power supply matches voltage printed on
power adapter. (Use only the adapter provided with the balance.)

Disconnect the balance from the power supply when cleaning.

Do not operate this product in hazardous or unstable environments.

Do not drop loads on the pan.

Use only approved accessories and peripherals, as available.

Operate the product only under ambient conditions specified in the Instruction Manual.

Service should be performed by authorized personnel only.
CONTROLS
Button Functions
Zero
Yes
Short Press (when on): Sets display to zero
(when off): Turns balance on
Long Press (when on): Turns the balance off
Short Press (in Menu): Selects/accepts displayed setting
Print
Units
No Short Press: See Interface Manual for operation description.
Long Press: Toggles through active units
Short Press (in Menu): Toggles through available settings
Function
Mode
Back Short Press: Selects function setting
Long Press: Selects active Mode
Short Press (in Menu): returns to previous settings
Tare
Menu
Exit
Short Press: Enter / clear a Tare value
Long Press: Enters User Menu
Short Press (in Menu): Quickly exit User Menu
IR Sensor-Left
IR Sensor-Right IR Sensors can be programmed to act as “touchless” buttons.
(See Setup Menu, back page, to program sensors to act as specific buttons.)
IR Sensors can be activated by a hand or other object placed about 12mm (½ inch) above the sensor. Activation
distance varies with the reflective nature of the object. If unwanted activations occur, sensors can be turned off.
Control panel for
Standard (non-
approved) models
Control panel for
approved models