Security device acc, Security device accessory, Obsolete, no longer available – Ohaus MB301 Electronic Balances User Manual

Page 26: Installation instructions, Other balances

PRECAUTIONS

•

Select a location on the balance where drilling will not
damage any internal components.

•

If uncertain, contact balance manufacturer for recom-
mendations.

•

Make sure that chips caused by drilling do not get into
the mechanism of the balance.

•

Verify that operation of balance will not be obstructed
when Security Device Bushing is installed in the bal-
ance.

Security Device

Accessory

P/N 76288-00

MB 300, MB301 and B Series Balances

The Security Device Bushing is not re-
quired on these balances.

To install, simply pass the Cable through
the hole in the pad between two heat
sink fins on the rear of the balance.

OHAUS

is the registered trademark of Ohaus Corporation as are the following

trademarks: CENT-O-GRAM

, CHECK-O-GRAM

, DEC-O-GRAM

, DIAL-O-GRAM

PRIMER

, 5-0-5

, and 10-10

Rear of

balance

Pass Cable

through hole.

Installation Instructions

The Security Device accessory kit is designed to protect OHAUS

balances against

theft. Before installing this accessory, carefully read these instructions. If assistance
is needed, contact Ohaus Corporation:

•

In the U.S., call toll-free at 1-800-526-0659.

•

In New Jersey, call 1-201-377-9000.

P/N 76438-00 R0793

Other Balances

The Security Device may be used with other balances however, a 1/2” diameter hole
may need to be drilled in the balance to accept the Security Device Bushing. If so, the
following precautions must be taken:

OHAUS CORPORATION

OHAUS CORPORATION
P.O. Box 900
29 Hanover Road
Florham Park, N.J. 07932, USA
Tel: 201-377-9000
Telex: 6853191 OHAUS UW
Fax: 201-593-0359

With other offices in England, Mexico, Canada,
Japan, Germany, France, Switzerland

OBSOLETE, NO LONGER AVAILABLE