Ohaus CL PORTABLE BALANCES Manual multi - Manual (Page 4)

EN-3 CL Series Scales
3 T
•
cale is on. Press and hold this button for
• weighing unit. Press and
on to begin the calibration process.
r intervals. This is especially important if
e scale is in use for prolonged periods.
Cali tio
•
• tion process can be aborted by turning the
•
s –C– while the scale stores the zero
• here xxx is the
• ppropriate calibration weight on the
• hile the scale stores the
• e display returns to the normal
bration steps are not
followed or the wrong weight was used.
3. OPERATION
.1 wo Button Keypad
ON/ZERO OFF: Pressing this button turns on the scale. This same button
operates the zero feature when the s
three seconds to turn the scale off.
UNIT CAL: Press this button briefly to change the
hold this butt
3.2 Calibration
For best results calibrate the scale at regula
th
bra n weights are not provided with the scale
Press and hold the UNIT CAL button to start the
calibration process. The display will show CAL.
The calibra
scale off.
Press the ON/ZERO OFF button to capture 0. The
display show
load signal.
The display will show C xxx w
calibration weight in grams.
Place the a
platform.
• Press the ON/ZERO OFF button.
The display shows –C– w
calibration point signal.
After calibration, th
weighing mode.
The message CAL E will appear if the cali