Naxa NPB-252 - Manual (Page 7)

E-6
CD OPERATION
CD PLAYER OPERATION
1. Set the Function Switch(CD/OFF/Radio) (#16) to the "CD" position.
2. Open the CD Door (#8). Place an audio CD with its label side upward in the CD compartment and
close the CD Door.
3. After a few seconds, the total number of tracks on the CD will appear in the CD LCD Display (#9) .
4. Press the PLAY/PAUSE Button ( 13#) and the CD will start playing from the first track.
5. Adjust the Volume Control (#2) to obtain the desired sound level from the Speakers (#17) .
6. To suspend playing, press the CD PAUSE Button (#13). The LCD Display will flash. To resume playing,
press the CD PLAY Button again.
7. You can choose to play your favorite track directly by pressing the F.F Button (#14) /Rew Button (#12)
skip forward or skip backward. The LCD Display (#9) will indicate the correct track number selected.
8. To repeat playing a particular track, press the REPEAT Button (#3) once.
9. To repeat playing the entire CD , ,, press the REPEAT Button (#3) twice.
10. To stop playing, press the CD STOP Button (#4).
11. When you wish to turn off the CD Player, set the Function Switch(CD/OFF/Radio) (#16) to the "OFF"
position.
MP3 PLAYER OPERATION
1.
PLAY/PAUSE
Press PLAY/PAUSE button (#13) one time play MP3 and press PLAY/PAUSE button (#13) two times to
suspend.
2. you can choose to play your favorite track directly by pressing the F.F Button (#14) /Rew Button
(#12) to skip forward or skip backward.The LCD Display (#9) Will indicate the correct track number
selected.
3. To repeat playing a particular track, press the REPEAT Button (#3) once. The Repeat Indicator in the
CD Track Display will flash.
4. To repeat playing the entire CD , , , press the REPEAT Button (#3) twice.
5. To stop playing, press the STOP Button (#4)
CD/MP3 PROGRAMMED PLAY
This function allows the tracks to be played in a programmed sequence.
1. Under CD stop condition, press the PROG+10 Button
(#5) . The LCD Display (#9) will display “01”
2. Press the F.F Button (#14) to select the song to be programmed.
3. Press the PROG+10 Button (#5) again to store selection. The LCD Display (#9) will advance to “02”.
4. Press the Rew Button (#12) to select the next song to be programmed and press the PROG. Button to
store selection.
5. For CD/CD-R/CD-RW play,you may repeat steps #2 - #3 to program as many as 20 tracks. If you
attempt to program more than 20 tracks, the LCD Display (#9) will revert to “01” and the old entry will
be overwritten by the current new entry!
6. Press STOP Button (#4) to end programming and return to normal play mode.
7. To check the programmed tracks, press PROG+10 Button (#5) continuous to show all the programmed
songs. The LCD Display (#9) will display the program number first and then followed by the flashing
track number.
8. Press PLAY/PAUSE Button (#13) to begin programmed play. The first track in program will appear in
the LCD Display (#9) .
9. To cancel programmed play, press the STOP Button (#4) .
10. As long as the unit remains on and the CD Door (#8) is not opened, you can resume programmed play
any time by pressing the PROG+10 Button (#5) and then PLAY/PAUSE Button (#13) in stop condition.