Naxa NPB-251 - Manual (Page 7)

E-6
CD OPERATION
NOTE: This unit not only plays commercial compact discs but also self-compiled CD-RW discs.
• Because of non-standardised format definition/production of CD-R/RW, playback quality &
performance is not guaranteed.
• Manufacturer is not responsible for the playability of CD-R/RW due to recording conditions such as
PC performance, writing software, media properties etc.
• Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a malfunction.
PLAY MODE
1. Slide the FUNCTION SWITCH to the “CD” position.
2. Open the CD DOOR（#8）, load a CD with the label side facing upward and then close the CD door
（ #8）.
3. Disc information (total number of tracks) will appear on the LED DISPLAY（#9）.
4. Press PLAY/PAUSE BUTTON（#13） to start playing the CD, the PROGRAM/PLAY INDICATOR will
light steadily.
5. While playing, press the PLAY/PAUSE BUTTON（#13） to pause, the TRACK No. will flash. Press
PLAY/PAUSE BUTTON（#13） again to resume playing.
6. Adjust the VOLUME CONTROL（#2） to the desired volume level.
7. Press STOP BUTTON（#4） to stop playing.
8. To turn off the CD player, slide the FUNCTION SWITCH （#16）to “OFF”.
NOTE:
If skipping occurs during CD play, try turning the volume down.
Do not open the CD DOOR when a CD is playing.
REPEAT MODE
Repeat 1
When the REPEAT BUTTON （ #3 ） is pressed once, the REPEAT INDICATOR will light and blink
continuously. The current track will be repeated until it is interrupted.
Repeat All
When the REPEAT BUTTON（#3） is pressed twice, the REPEAT INDICATOR will light steadily. The whole
disc will be played continuously.
To Cancel Repeat Function: Press the REPEAT BUTTON（#3）until the repeat indicator is off.
SKIP AND SEARCH MODE
1. During Play or Pause mode, tap the SKIP FORWARD ""（#14） or SKIP BACKWARD "" BUTTON
（ #12） to go to the next track or go back to the beginning of the current track.
2. During play mode or Pause mode, press and hold the SEARCH FORWARD "" （#14）or SEARCH
BACKWARD "" BUTTON （#12）to search within the current track with audible high speed playback.
PROGRAM PLAY MODE
This function allows music tracks to be played in a programmed sequence.
NOTE: Program can only be set in STOP mode.
1.
Press the PROGRAM BUTTON（#5） once. “01” in the LED DISPLAY （#9）and PROGRAM
INDICATOR both will flash.
2. Press the SKIP FORWARD ""（#14）or SKIP BACKWARD "" BUTTON （#12）to select the track
to be programmed.
3. Press the PROGRAM BUTTON （#5）again to store the selection. The LED DISPLAY（#9） will
advance to “02” and flash to prompt for the next input.
4. You may repeat steps #2 to #3 to program up to 20 tracks. As soon as you have entered the 20th track,
the LED DISPLAY will automatically show the programmed tracks one by one in their correct sequence
starting from the first. At the end of program review, “01” in the LED DISPLAY and PROGRAM
INDICATOR will both flash.
5. Press PLAY BUTTON（#13） to complete and start program play. The PROGRAM/PLAY INDICATOR
will blink. Press STOP BUTTON（#4）to stop.