Specifications – Naxa NPB-245 User Manual

Page 7

To Erase the Memory (Program)
To clear the program, you have two options:
1. Press the STOP button when the disc is stopped, or
2. Open the CD compartment lid, program will be erased.

REPEAT

You can play one track or all tracks on the disc repeatedly.

To Repeat a Single Track

1. Press the REPEAT button once during play, the CD REPEAT indicator will flash on and off.

The current track will be played over and over again till you press the STOP button.

2. To cancel repeat play, press the REPEAT button twice. the CD REPEAT indicator turns off.

To repeat all Tracks

1. Press the REPEAT button twice during play, the CD REPEAT indicator becomes steady on, all

tracks on the disc will be played over and over again till you press the STOP button.

2. To cancel repeat play, press the REPEAT button once, the CD REPEAT indicator turns off.
Note: Repeat function also can be done in stop mode.

SPECIFICATIONS

CD SECTION

Channels:

channels

Optical

pick-up:

beams

laser

Frequency Response:

100Hz - 16KHz

RADIO SECTION

Receiving

Band:

AM/FM

Tuning Range:

AM: 530 - 1600 KHz

FM:

108

MHz

Antenna:

FM rod antenna, AM built-in ferrite bar

GENERAL

Output Power:

1.2 W x 2 (RMS)

AUX IN Jack:

3.5mm

Power Source:

AC 127V ~ 60Hz

1.5V

UM-2/C

6pcs

Power Consumption:

13.5W

Note: Specifications are subject to change for continuous improvement without prior notice.

ESD Remark:

In case of malfunction due to electrostatic discharge, just reset the product (reconnect of power
source may be required) to resume normal operation.