Warning, Dollhouse, Mounting hardware – Land of Nod Dollhouse Bookcase User Manual
Page 5: Tools required wall mounting assembly

For added safety and stability, it is recommended that the wall mounting hardware be installed. For safe mounting, it is
essential to use wall anchors appropriate to your wall type (i.e. plaster, drywall, concrete, etc.). Mount to wood studs
whenever possible.
A) Attach
mounting bracket to top of unit using 2 small screws.
B) Determine the final location of unit. Mark position on the wall, approximately 2" below the mounting bracket mounted to
the back of the unit.
C) Drill a hole in the wall stud. If the wall stud is not available, drill a hole in the wall that is slightly smaller in diameter than
the anchor. Gently tap the
plastic anchor until the flange of the anchor is flush with the wall.
D) Attach the
mounting bracket to the wall by inserting 2 large screws through the mounting bracket and into the wall
anchor in the wall.
E) Place the unit so the mounting bracket on the back edge is allowed with the wall bracket.
F) Lace one end of the
wall strap through both brackets, and into the other end of the strap.
G) Pull the strap tightly until secure.
Repeat step A-G for remaining wall mounting assembly.
NOTE: If you are unsure about your wall type or what mounting method you should use, consult a qualified
professional.
Wall mounting assembly is now complete.
DOLLHOUSE
BOOKCASE
Made in Vietnam - r06
Page 5 of 5
Customer Service
800.933.9904 | Latest instructions available at www.landofnod.com
A
C
D
small
screw
mounting
bracket
plastic
anchor
large
screw
wall
strap
mounting
bracket
Serious or fatal crushing injuries can occur from furniture
tip over. Use of tip-over restraints may only reduce, but
not eliminate, the risk of tip-over. To help prevent tip-over,
install tip restraint per instructions below.
WARNING
!
4 - small
screws
4 - large
screws
4 - plastic
anchors
4 - mounting
brackets
Missing hardware? Please call
800.933.9904
for replacements. NOTE: Contains small
parts. Keep away from small children.
MOUNTING HARDWARE
2 - wall straps
TOOLS REQUIRED
WALL MOUNTING ASSEMBLY
power drill
(for pilot holes only)
phillips head screwdriver