DB Drive A72500.1 - Manual (Page 6)

Remote turn on
12V
3-4. SPEAKER CONNECTION
DB Drive recommendes to use minimum 12 gauge speaker connecting cables.
Run 12 gauge speaker connecting cables from your speakers to OKUR
amplifier's mounting location
Keep speaker cables away from power cables and OKUR amplifier's input cables.
Use grommets anywhere the cables have to pass through the holes in the metal frame or sheet metal.
Connect to the speakers according to the type of the terminals on each speaker.
Strip 3/8" of insulation from the end of each cable and twist the cables strands together
tightly. Make sure there are no stray strands that might touch other cables or terminals and cause
a short circuit.
Crimp spade lugs over the cable ends or tin the ends with solder to provide a secure termination.
Connect the cable ends to Platinum series amplifiers as speaker system diagram
CAUTION !!
Ground
OKUR +12V, GROUND, REMOTE CONNECTION DIAGRAM
BATTERY
OKUR DIGITAL AMPLIFIERS’ SPEAKER CONNECTION DIAGRAM 1.
8~ 1 ohms
A7750.1, A71100.1, A71500.1, A72000.1,
A72500.1 amplifiers
minimum impedance is 1 ohms.
Linked minimum impedance is 2 ohms.
5