Concord TRANSFORMER T INSTRUCTION MANUAL - Manual (Page 11)

41 40
Pull the belt taut so that the lap belt and diagonal belt are well positioned and ensure
that the belts are not twisted. The lap belt should be in the lowest possible position.
If your vehicle is fitted with a seat belt height adjuster, adjust its height accordingly.
When you wish to release the child from the seat, all you need to do is open the lock
and pass the strap back across the child. To remove the shoulder belt from the guide,
press the shoulder belt locking button ( 05 ) and pull the belt forwards and out.
It is important to ensure that the belts are always correctly positioned each time the seat
is used. If in doubt about any aspect of fitting, check with CONCORD.
The belts must pass through the guides marked in red on the seat. Belts must not be
routed in any other way.
_ CArE iNSTrUCTiONS
The cover can be removed for washing.
To do so, move the head section ( 01 ) to its highest
position. To remove, pull the cover away from its
anchoring points. Begin by removing the head section
( 01 ) followed by the seat section and the shoulder
shields ( 02 ).
To replace, start with the cover for the seat section.
Firstly, pull the cover over the cover panel on the
backrest, and then, from the front, pull it over the
armrests and seat section. Secure the cover using all of
the fastening points and the zip fastener on the back.
Finally, attach the cover for the head section ( 01 ) and
shoulder shields ( 02 ).
• When they come into contact with moisture,
especially during washing, the cover fabrics may
fade slightly.
• Do not use solvents!