Concord LIMA INSTRUCTION MANUAL - Manual (Page 6)

16 17
Centre belt
Waist belt
_ ATTACHING AND REMOVING THE TRAy
To attach the tray to the CONCORD LIMA, first release the press studs on
the seat cover (
04 ) and undo the Velcro fastener that is on the backrest
cover ( 01 ). Next fold back the backrest cushion. Now position the tray on the
backrest and ensure that it engages. Finally, secure the backrest cover over
the attached tray.
CAUTION!
• When used with the tray, it is essential that the tabs on the side of the
seat cover pass over the side sections of the tray and are secured to
the side press studs.
To remove the tray, first fold back the
backrest cushion and undo the press studs
on the side tabs of the seat cover.
Then release the lock (
05 ) on the back of
the backrest and pull the tray upwards and
away from the backrest.
If you wish to use the CONCORD LIMA without the tray, secure the side tabs
of the seat cover using the press studs on the back of the backrest.
_ USING THE SEAT BELTS
Feed the centre belt through between the child‘s legs. Feed one of the two
waist belts through the loop on the end of the centre belt. Adjust the waist
belt by sliding the belt buckle until the belt lies tautly across the child and
fasten the belt lock. Check that the belt fastenings engage with an audible
click.
CAUTION!
• For safety reasons, all the straps on the CONCORD LIMA are not just
tightened, but have to be adjusted by sliding the belt buckle on the belt
to the correct length.