Bosch GWS 24-230 LVI Professional - Manual (Page 16)

16 | English
1 609 92A 0B9 | (31.7.13) Bosch Power Tools
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
21.06.2013
Noise/Vibration Information
The measured values of the machine are listed in the table on
page 246.
Noise and vibrational values (vector sum of three directions)
determined according to EN 60745.
The vibration emission level given in this information sheet
has been measured in accordance with a standardised test
given in EN 60745 and may be used to compare one tool with
another. It may be used for a preliminary assessment of expo-
sure.
The declared vibration emission level represents the main ap-
plications of the tool. However if the tool is used for different
applications, with different accessories or poorly maintained,
the vibration emission may differ. This may significantly in-
crease the exposure level over the total working period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working pe-
riod.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and the
accessories, keep hands warm, organise work patterns.
Mounting and Operation
The following table indicates the action objectives for mounting and operation of the power tool. The instructions for each action
objective are shown aside. Depending on the type of application, various instruction combinations are required. Observe the
safety instructions.
Henk Becker
Executive Vice President
Engineering Helmut Heinzelmann
Head of Product Certification
PT/ETM9
Action Figure Please observe Page
Grinding, preparation 1 247 – 248
Cutting, preparation 2 249 – 250
Cutting stone, brick and tiles,
preparation (recommenda-
tion) 3 251 – 252
Removing paint, preparation 4 253
Removing rust, preparation 5 254
Mounting the quick-clamping
nut 6 255
30°
OBJ_BUCH-1528-002.book Page 16 Wednesday, July 31, 2013 10:38 AM