Olympus FL-14 - Manual (Page 10)

12 EN
Shooting (AUTO) Shooting (AUTO)
In AUTO mode, the auto light receptor adjusts adequate lighting for subject, and light is
emitted according to the camera settings (ISO sensitivity and aperture value). No pre-fl ash is
used, and release time lag is reduced.
1
Press the MODE button of the electronic fl ash repeatedly to set the fl ash control
mode to [AUTO].
2
Use “Available shooting range” (Table p. 4) as a guide to fi x the distance to the
subject and then shoot.
When fl ash activation has been performed correctly, the AUTO CHECK lamp blinks for
about 5 seconds after the shooting.
Flash can be tested before shooting; press the TEST button to test fl ash activation.
When the AUTO CHECK lamp blinks for about 5 seconds, the fl ash is adjusted
correctly.
For cameras without communication capability For cameras without communication capability
Set the ISO sensitivity and aperture value by referring to the section of the “Available
shooting range” (Table p. 4), and shoot within that range.
•
•