Binatone HC-430 - Manual (Page 11)

11
ENGLISH
Mid-sized hair-cut (Fig. 4)
For this hair-cut, install the attachment (7 A or B) to the posi-
tion from 1 to 7 dependent on the area being cut (Fig. 4a). This
hair-cut gives a flat surface to the back of the head.
X The most important prerequisite for each hair-cut is to properly
dry hair before cutting. Dry the hair against the hair growth
direction to bristle the hair (Fig. 4b).
X Start hair cutting from the back and sides (Fig. 4а) (ref. to the
Short hair-cut section).
X To enable you to obtain a smooth finish, use the barber hair-
brush (12) or fingers (Fig. 4с). Remove the hair-cutting at-
tachments (7 ) from the device. Using the barber hairbrush
(12) or fingers, lift a small hair strand (hair should be in a
vertical position as compared to the head), move the hairbrush
(12) or fingers along the strand length until you get the de-
sired length. The height of the cut strand is the example for the
next one. Continue cutting strand-by-strand, moving from the
back towards the forehead. Regularly comb hair to remove
cut strands and check the hair-cut results.
X For obtaining a smooth transition area (marked with a bold line
in Fig. 4а), located between the head back hair and the side
hair, slightly decline a flat hairbrush and cut-off the standing
hair (Fig. 4d).
X Cut hair-cut contours and whiskers as shown in the
Short hair-cut section.
Long hair-cut
This kind of hair-cut with hair cut off at the sides and at the back
gives long front hair.
X Cut the back and side hair following the procedure described
in the Short hair-cut section. Cut the hair only until the bold
line in Fig. 4а.
X Starting with this level (located several centimeters above the
ear), use a flat hairbrush to obtain a smooth transition zone.
Decline the hairbrush against the head and cut off the stand-
ing hair using the hair-cutting device without any attachment
(7). In this case the hairbrush serves as a guide (Fig. 4d).
X Do not cut hair from the top.
X Cut hair-cut contours and whiskers as shown in the Short
hair-cut section.
X Comb the hair as desired.
How to maintain the hair-cut
To maintain the hair-cut, from time to time trim the hair-cut
contours on the head back, whiskers and hair around the ears as
described in the Short hair-cut section. For this, no attachments
(7) is used.
Beard cutting
X Start cutting the beard under the chin. Move the device sym-
metrically either to one side, or to the other (Fig.5).
X Hair out of the beard contour should be cut with an upturned
device, with no tip attached. Cut hair in short careful moves.