Acura 2012 RL - Manual (Page 191)

The outer rear seat cushions and
seat-backs are equipped with seat
heaters.
The rear seat heater switches are
located under the rear vents. The
left (right) switch controls the seat
heaters on left (right) outer seating
position.
The ignition switch must be in the
ON (II) position to use seat heaters.
Push the right side of the switch, HI,
to rapidly heat up the seat. After the
seat reaches a comfortable
temperature, select LO by pushing
the left side of the switch. This will
keep the seat warm.
In the HI setting, the heater turns off
when the seat gets warm, and turns
back on after the seat’s temperature
drops.
In the LO setting, the heater runs
continuously. It does not cycle with
temperature changes.
Follow these precautions whenever
you use the seat heaters:
Do not use the seat heater in the
HI setting for an extended period,
because it draws large amounts of
current from the battery.
If the engine is left idling for an
extended period, do not use the
seat heaters even on the LO
setting. It can weaken the battery,
causing hard starting.
CONTINUED
Rear Seat Heaters (Canadian models)
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
185
HEATERS
For right outer
seating position
HEATERS
For left outer
seating position
LOW HI
REAR SEAT HEATER SWITCHES
11/07/20 18:23:51 31SJA670_190