ARIETE Twin Aqua Power 2477 - Manual (Page 22)

FABRIC CLEANING NOZZLE (G) AND BRISTLED ATTACHMENT (H)
This is particularly suited for cleaning surfaces such as armchairs, rugs, and smaller-sized hard
surfaces, and also for fabrics and curtains. It can be fitted to the hand grip (A) or tube (L) (Fig. 18).
The bristled attachment (H) can be fitted to the nozzle (G) and it is recommended for cleaning small-
sized fabric surfaces.
KIT FOR CLEANING GLASS AND WINDOWS (I)
Ideal for large glass surfaces, large mirrors, and smooth surfaces in general. It can be fitted to the
hand grip (A) or tube (L). To use the glass washer correctly, proceed as follows:
- evenly dispense the cleaning agent over the surface to be cleaned so as to dissolve the dirt.
- press the rubber scraper over the surface to be cleaned, moving it in vertical strokes from top to
bottom, with the suction function on.
CLEANING AND MAINTENANCE
WARNING: Before carrying out any cleaning or maintenance operation, switch off the appliance and
unplug it from the mains power.
In the interests of hygiene, after using the appliance, rinse out the attachments by vacuuming up
clean water. In this way the attachments and the inside of the hose will be cleaned.
Use a damp cloth to wipe the outside of the appliance clean. Do not use solvents or cleaning agents
that could damage the plastic surfaces.
A few simple maintenance operations are necessary to make sure that the appliance will always
operate perfectly.
Emptying and cleaning the dirty water container (6)
Open the cover (11) of the appliance as described previously (Fig. 1-2).
Take the dirty water container (6) by its folding handle (4) and remove it from the appliance body
(Fig. 19).
WARNING: Do not remove the lid (1) from the container before reaching the place where it is to be
emptied; this is to avoid any liquid spills while carrying it.
As soon as you are ready, remove the cover (1) and empty out the container (6), pouring from the
narrowest edge (Fig. 20). Clean out the container with water and a mild soap.
Follow the above steps in reverse order to re-fit the container to the appliance, making sure it is in
its seating by pressing it down gently (Fig. 21). Make sure that the container is properly attached
to the pump valve (13).
WARNING: Before using the appliance, make sure that all filters have been fitted perfectly in the
correct position.
Triple filter for exhaust air (15)
Remove the grille in the back of the appliance, pressing the top clip at the same time (Fig. 22).
Remove the filters and clean under running water, if necessary; leave to dry thoroughly. The filters
GB
- 20 -