Activeforever PAL 1000 Portable Aquatic Pool Lift - Manual (Page 13)

Unpacking Procedure for the Splash!
For easiest assembly, move pallet to an area near the deck anchor where the
Splash! will be used.
1. Cut open the enclosure bag at the base of the unit and gently remove
plastic from unit.
2. Carefully cut black bands around components
3. Remove the housing cover, accessory box, and chair assembly. Remove
plastic wrap from housing cover.
4. Remove the base assembly from the pallet and insert into mounting
sleeve/anchor on pool deck.
5. Remove 2 lock nuts and washers from the mounting hub on the base
assembly. Place housing cover over base unit . Line up holes in cover with
holes on base assembly.
6. Position mast assembly onto housing cover and attach to studs with lock
nuts and washers. Fully tighten with 3/4” socket wrench. Slide attachment
cover down to cover bolts.
7. Remove twist-tie and uncoil actuator cable at bottom of mast.
8. Make sure that console clears the housing and adjust if necessary.
9. Run actuator cable to console bracket and insert into receptacle #1 on the
control box. Be sure plug is pushed in all the way.
10. Remove and unwrap hand control from accessory carton. Insert connector
into large receptacle on control unit.
11. Attach battery to control unit mounted on console.
12. Check up and down control for proper operation.
13. Check side to side control for proper operation.
14. Attach chair assembly to chair support arm with lock pin into the
appropriate hole. To facilitate storage, chair can be attached facing inward,
which will require less space.
15. Attach foot rest to seat with attached pins.
12
Please call ActiveForever at 800-377-8033
if you have any problems
or questions with assembly.