Acroprint Data Collection Terminal (ADCT) - Manual (Page 4)

4
Basic hardware and variations
The electronic hardware is a new, versatile platform designed for
use with various applications. This manual describes, in detail, the
electronic hardware aspects of the terminal you have purchased.
The details concerning terminal firmware and host software are
addressed in the manual which comes with the software.
All terminals are equipped with:
1) a magnetic stripe reading head
2) a 2 row x 20 character per row display
3) a 16-key full travel keypad
4) an RS-232 serial port
5) a wand port for optional bar code wand
6) two control lines for external relay control (door access,
and bell ringer are typical applications)
7) a 25-pin parallel port
The terminal is offered in different hardware variations. Listed
below are the variations by part number and description:
Part # Description
C - Programmable e-prom (DataLog)
01-0120-000 DataLog with LAN (RS-485)
01-0120-002 DataLog with Modem (no LAN)
01-0120-003 DataLog with LAN & Internal Visible Bar Code Reader
01-0120-004 DataLog with Modem & Internal Visible Bar Code Reader
01-0120-005 DataLog with LAN & Internal Infrared Bar Code Reader
01-0120-006 DataLog with Modem & Internal Infrared Bar Code Reader
01-0120-008 DataLog with Ethernet
01-0120-010 DataLog with Ethernet & Internal Visible Bar Code Reader
01-0120-012 DataLog with Ethernet & Infrared Bar Code Reader
Acrocomm e-prom (Acroprint Data Collection Terminal — ADCT)
01-0147-000 Acroprint with LAN (RS-485)
01-0147-002 Acroprint with Modem (no LAN)
01-0147-003 Acroprint with LAN & Internal Visible Bar Code Reader
01-0147-004 Acroprint with Modem & Internal Visible Bar Code Reader
01-0147-005 Acroprint with LAN & Internal Infrared Bar Code Reader
01-0147-006 Acroprint with Modem & Internal Infrared Bar Code Reader
01-0147-008 Acroprint with Ethernet
01-0147-010 Acroprint with Ethernet & Internal Visible Bar Code Reader
01-0147-012 Acroprint with Ethernet & Infrared Bar Code Reader
Note: The part number of your unit can be found on the serial
number label on the back of the terminal.
1. Introduction
Introduction