ACR&Artex RCL-100D - Manual (Page 6)

Y1-03-0138V 6
standard "F" type television connectors. The connector on the back of
the Point Pad™ is located in the center of the panel for ease of
installation. After the coax cable has been routed and t
he “F”
connectors attached to the coax cable, simply screw the “F”
connectors to the Master Controller and the Point Pad™. The cable
and connectors are available either through ACR Electronics, your
local Radio Shack or other sources of electronic hardware.
Additional Point Pads™ (up to three (3) Pads) may be used with one
(1) Master Controller. A standard "T" connector or RG-59 television
type "splitter" is used for each additional Point Pad

(see Figure 2).
Limit the total length of all coax cable used to 300 feet.
The URP-
102 Point Pad™ is backwards compatible with all RCL-
100/50 Searchlights and with the URC-101 Master Controller.
NOTE: The URP-
102 Point Pad™ is not recommended for use with
the first generation URC-100 Master Controllers.