Acme IB-100 - Manual (Page 11)

11
GB
features
Water spray
1. The spray function can be used in any position, either in dry or steam ironing, as long there is
water in the water tank.
2. Press the spray button to use this function.
Note: When using this function for the first time, the spray button may have to be pressed repeatedly
Shot of steam
The “Shot of steam” function produces extra steam for removing persistent wrinkles.
1. Set the temperature control dial to the “Max” position (Fig. 3) and wait until the pilot light goes
out.
2. Wait for a few seconds before pressing again, for the steam to penetrate deeply into the fibre.
Note: For the best steam quality, do not use more than three successive bursts each time. Some
pumping action is needed to start this function.
Excessive use of this feature will cause the iron to cool, therefore ensure that the pilot light is out
before operating the “Shot of steam” control.
Anti-drip function
This function automatically stops producing steam when the temperature is too low to prevent
water from dripping out of the soleplate.
Automatic Anti-Calc function
The built-in Anti-Calc system reduces the build-up of scale and guarantees a long life for the iron.