Acme KB-100 - Manual (Page 7)

6 7
GB
operation
It is recommended to use the kettle for several times following instructions given below and to
remove remaining water before first usage. This will remove any materials or dust remained in the
appliance from the manufacturing process.
1. Open the lid by turning the Lid up while pressing the Lid button and pour water into the kettle.
Then replace the lid, otherwise the kettle would not be able to turn off the power automatically
after water has boiled.
Caution: the filled water level must be between the “Max” and “Min” level as indicated on the housing. Too little water
will damage the heat element and if the kettle is overfilled, boiling water may splash out.
2. Replace the kettle on the power base and connect to power supply. Position the kettle so that
the spout of the kettle is facing away from you.
3. Press the switch button to “I” position and the light will flash on. And water will start to heat up.
Do not open the lid while the water is boiling.
Caution: Ensure that the switch is clear of obstructions and the lid is firmly closed. The kettle will not turn off if the
switch is constrained or if the lid is left open.
4. Power will be cut off automatically and the switch will be back to “0” position once water has
been boiled. And the light will be off.
5. Lift the kettle from the power base and then pour the water.
Note: Be careful when pouring water from the kettle,
as boiling water may cause scalding.
6. The boiling process can be terminated at any
time by lifting the kettle off the power base or
pressing the switch to “0” position. „I” „0”