Remington PG6050 - Manual (Page 4)

6 7
ENGLISH ENGLISH
,Using the miniscreen shaver
• Hold the groomer so the MiniScreen gently touches your face.
• Use short, and well-controlled movements to shave around your beard/moustache.
Use your free hand to stretch your skin. This encourages the hair to stand upright,
making it easier to shave .
Note: The MiniScreen shaver was designed to shave the detail areas around your
beard/moustache/sideburns. It was not designed to shave your entire face. For a close
comfortable shave, guaranteed, use one of Remington’s electric shavers.
,Trimming body hair
• Attach Body Hair trimmer attachment head.
• To achieve the desired hair length, change the guide comb by easily sliding it onto one
of the three slots on the attachment head. The different slots represent 2.8mm,
5.6mm & 9.6mm hair lengths
• Place the flat top of the trimmer comb against the skin.
Slowly slide the trimmer through the hair, in the direction of hair growth.
• Use slow and well-controlled movements.
• If hair builds up in the guide comb during the trimming process, switch the unit off,
pull off the guide comb. Brush trimmer / rinse comb.
, Removing body hair
• To remove the hairs completely, trim the hair down to 1.2mm without attaching the
guide comb and then change to the Mini Screen attachment head.
• Hold the shaving head to your skin.
• Stretch your skin with your free hand so hairs stand upright.
• Only apply light pressure on the shaving head whilst shaving.
• Shave against hair growth.
C CARE FOR YOUR GROOMER
Care for your product to ensure a long lasting performance. We recommend that you clean
your groomer after each use.
The easiest and the most hygienic way to clean the groomer is by rinsing the product head
after use with warm water. Always keep the protective cap on the shaving head and keep the
trimmer in the “off” position when the shaver is not in use.
E After each use
• Rinse the accumulated hair from the cutters and shake off excess water. Alternatively,
use a brush.
• Gently tap on a flat surface to remove hair particles, and brush the remaining hairs
away.
• Place one or two drops of cutter oil or sewing machine oil on the blades. Turn the
clipper on to distribute the oil evenly, wipe off any excess oil.
• Wipe the main unit with a damp cloth and dry immediately.
Note: Ensure that the groomer is turned off when applying the oil or rinsing under the
tap.
F IMPORTANT SAFETY INSTRUCTIONS
Warning – To reduce the risks of burns , electrocution , fire, or injury to persons:
•
The appliance must only be used by or under the supervision of a responsible adult.
• Use and store the appliance out of reach of children.
• Do not use accessories or attachments other than those we supply.
• This product is battery operated only
• This product uses alkaline batteries. At the end of their life the batteries must be
removed from the appliance and be recycled or disposed of properly in accordance with
your state and local requirements.
• Do not put in fire or mutilate your batteries when disposing as they may burst and
release toxic materials.
• Do not short circuit as it may cause burns.
• Store the appliance at a temperature between 15°C and 35°C.
• Do not use accessories or attachments other than those we supply.
• The appliance, including its cord, must not be used, played with, cleaned or maintained
by persons under eight years old and should at all times be kept out of their reach.
• Use, cleaning or maintenance of the appliance by children over eight or by anyone with
a lack of knowledge, experience or with reduced physical, sensory or mental capabilities
should only be undertaken after receiving appropriate instruction and under the
adequate supervision of a responsible adult to ensure that they do so safely and that the
hazards involved are understood and avoided.
• Don’t put the appliance in liquid, don’t use it
near water in a bath-tub, basin or any other
vessel, and don’t use it outdoors.
• Turn on the groomer before you insert it into your nose or ear to avoid
injury.
H ENVIRONMENTAL PROTECTION
To avoid environmental and health problems due to hazardous substances in electrical and
electronic goods,
appliances marked with this symbol must not be
disposed of with unsorted municipal waste, but recovered, reused or
recycled.
F BATTERY REMOVAL
• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing the battery.