Remington D5800 - Manual (Page 4)

ENGLISH
2
CLEANING AND MA INTENANCE
To maintain peak product performance and to prolong motor life, it is important to regularly
remove dust and dirt from the rear grille and clean with a soft brush.
To remove the rear grille for cleaning – Hold the dryer handle in one hand, then with the
other place your thumb and index finger on the indents either side of the rear grille. Pull the
rear grille away from the dryer – you can then clean this area with a soft cloth or brush.
To replace the rear grille hold in place with thumb and index finger again and click back
onto the dryer.
SAFETY CAUTIONS
WARNING – FOR ADDITIONAL PROTECTION THE INSTALLATION OF A
RESIDUAL CURRENT DEVICE (RCD) WITH A RATED RESIDUAL OPERATING
CURRENT NOT EXCEEDING 30mA IS ADVISABLE. ASK AN ELECTRICIAN FOR
ADVICE.
WARNING – THIS APPLIANCE MUST NOT BE TAKEN INTO A BATHROOM.
IT SHOULD NOT BE USED NEAR BATHTUBS, SHOWERS, BASINS OR
OTHER VESSELS CONTAINING WATER OR OTHER LIQUIDS.
This product is not suitable for use in bath or shower.
THE HAIRDRYER SHOULD BE UNPLUGGED FROM MAINS SUPPLY WHEN
NOT IN USE.
Do not leave the dryer unattended when switched on.
Allow the dryer to cool down before storage.
Do not immerse in water or other liquids.
Do not wrap the cord around the unit. Check cord regularly for any sign of damage.
Damaged cords can be dangerous.
In use, take care that the inlet and outlet grilles are not blocked in any way as this will
cause the unit to automatically stop. Should this occur, switch off and allow the unit to
cool down.
Ensure the inlet grille is free from obstructions such as household fluff, loose hair etc.
Do not place hairdryer on soft material e.g. carpet, bedding, towels, rugs etc.
Do not leave the dryer switched on when you set it down.
110444_REM_IFU_D5800_21L.indd GB_2 24.06.11 16:33