Remington HC5810 - Manual (Page 8)

ENGLISH
6
BATTERY REMOVAL
The battery must be removed from the appliance before it is scrapped.
The appliance must be disconnected from the supply mains when removing the battery.
Ensure the clipper is discharged of all power and disconnected from the mains.
Hold the clipper in one hand so that the blades are at the top, place your thumb
underneath the blades and press upwards, the blade set will detach from the clipper.
Using a screwdriver remove (2) screws from front of the clipper and remove the front
housing
Hold the rear of clipper in one hand and hold the Short Length Selection Dial in another
hand, rotating the Short Length Selection Dial left and right, put the Dial out.
Using a screwdriver remove (1) screw from the bottom of the clipper
Lift or pry the clipper halves apart, exposing the battery and printed circuit board.
Cut the tabs on both ends of batteries and remove it from the clipper.
The battery is to be disposed of safety.
SERVICE AND WARRANTY
This product has been checked and is free of defects. We warrant this product against any
defects that are due to the faulty material or workmanship for a 3 year period from the
original date of consumer purchase. If the product should become defective within the
warranty period, we will repair any such defect or elect to replace the product or any part
of it without charge provided there is proof of purchase. This does not mean an extension
of the warranty period.
In the case of a warranty simply call the Remington
® Service Centre in your region.
This warranty is offered over and above your normal statutory rights.
The warranty shall apply in all countries in which our product was sold via an authorised
dealer.
This warranty does not include the cutters which are consumable parts. Also, not covered
is damage to the product by accident or misuse, abuse, alteration to the product or use
inconsistent with the technical and/or safety instructions required. This warranty shall not
apply if the product has been dismantled or repaired by a person not authorised by us.
100166_REM_IFU_HC5810_21L.indd GB6 26.03.10 16:35