English, Wiring instructions uk plugs only – Remington CI9532 User Manual

Page 5

ENGLISH

FIN

HR/ SRB

Do not leave the styler unattended when switched on.
Allow the styler to cool down before storage.
Do not immerse in water or other liquids.
Do not place styler on soft material e.g. carpet, bedding, towels, rugs etc.
Always ensure the voltage to be used corresponds to the voltage stated on the unit.
Keep this product out of reach of children. The use of this appliance by persons with

reduced physical, sensory or mental capabilities or lack of experience and knowledge
can give cause to hazards. Persons responsible for their safety should give explicit
instructions or supervise the use of the appliance.

Do not use any attachments with this styler, other than those supplied by Remington

Avoid allowing any part of the hot plates to contact the face, neck or scalp.
Do not wrap the cord around the unit. Check cord regularly for any sign of damage.
This product is not intended for commercial or salon use.
Damaged cords can be dangerous. If the supply cord of this unit becomes damaged,

discontinue use immediately and return the appliance to your nearest authorised
Remington

service dealer for repair or replacement in order to avoid a hazard.

Special tools are required for any examination, adjustment or repair. Unqualified repair

work could lead to hazardous conditions for the user.

We do not accept responsibility for damage to the product, persons or other items(s),

caused by misuse, abuse or non-compliance with these instructions.

WIRING INSTRUCTIONS UK Plugs Only

This product is fitted with a BS1363 plug fused at 5A. If the plug is unsuitable, it should be
disconnected and an appropriate plug fitted as detailed below. If it is necessary to replace
the plug fuse, use only fuses that are approved to BS1362, rated at 5A. If in doubt consult a
qualified electrician.

The wires in the mains lead are coloured in accordance with following code:

BLUE - NEUTRAL
BROWN - LIVE

As these colours may not correspond with the coloured markings sometimes used to
identify the terminals in a plug connect as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked
„N“ or coloured BLACK. The wire which is coloured BROWN must be connected to the
terminal which is marked „L“ or coloured RED. Never connect either of the wires to the
big EARTH terminal marked „E“ or coloured GREEN or GREEN AND YELLOW.

110436 REM IFU Ci9532_21L.indd GB_3

24.06.11 17:08