Accell UltraRun 1.3 HDMI cable - Manual

Introduction: Congratulations on your purchase of the Accell UltraRun 1.3 cable. Accell UltraRun 1.3 cables are
designed to provide up to 1080p high-resolution transmission over long cable runs of up to 25 meters. The cable’s
built-in technology regenerates the digital signal before sending it to the display. The innovative removable repeater
design allows easy replacement of an inoperable repeater module without having to disrupt the long cable run.
Note: If running the cable in a wall, please connect the cable to the hardware to ensure successful
operation before installing the cable within the wall. To prevent damage to the HDMI screw connector,
when pulling the long cable length through the wall it is recommended not pull the side with HDMI screw
connector. Pull the HDMI connector on the cable side that will connect to the video source
Setup: Remove the protective plug from the repeater modules power jack. Plug the included power adapter into the
cable and then into an active power outlet. Remove the protective covers from each of the HDMI connectors. Connect
the long cable length to the video source. Connector the short cable length labeled “To Display” to the display.
Specifications:
HDMI 1.3 Category 2 High-Speed compliant up to 6.75Gbps (225MHz)
Supported Resolutions: Up to 1080p (120Hz). Computer: Up to 1920x1200
5VDC/0.5A (3.5mm center positive) power adapter
Operating Temperature: -40°F to 185°F (-40°C to 85°C)
Underwriters Laboratories (UL) CL3 rated and CSA FT4 rated.
Troubleshooting: If the cable fails to operate (no picture on the display) please check the status of the cable’s LED
light. The LED Light “On” is the normal operating condition.
A: Ensure the source device (example: DVD player) and display are plugged in and turned on.
B: Ensure the long cable is plugged into the video source. It should be connected and screwed tightly to the repeater
module. The booster end of the cable marked “To Display” must be connected to the display.
C: The cable may not be getting enough power. Check that the power adapter is plug into an active outlet.
Assistance: If you have questions please check out our Web site at: www.accellcables.com. Technical Support can be
reached by E-mail at [email protected] or at 510-438-9288 (M-F 9am-5pm PST).
LIMITED MANUFACTURERS WARRANTY
Accell UltraRun 1.3 cables which are purchased in the U.S.A., are warranted by Accell Corporation to be free of defects
in material and workmanship for 10 years from the date of purchase. In the event of such defects, the Accell product
will be repaired without charge or, at our option, replaced with a new one if delivered to Accell Corporation prepaid,
together with a copy of the dated sales receipt. This warranty excludes defects due to normal wear, abuse, shipping
damage, or failure to use the cable in accordance with the instructions. ACCELL CORPORATION SHALL NOT BE LIABLE
FOR DAMAGES BASED UPON INCONVENIENCE, LOSS OF USE OF THE CABLE OR OTHER ACCELL PRODUCT, LOSS OF
TIME, INTERRUPTED OPERATION OR COMMERCIAL LOSS, OR ANY OTHER DAMAGES, WHETHER INCIDENTAL,
CONSEQUENTIAL OR OTHERWISE. This warranty gives you specific legal rights, and you may have other rights that
vary from state to state.
Limitation Of Liability.
IN NO EVENT SHALL ACCELL CORPORATION, ITS SUBSIDIARIES OR AFFILIATES, OR THEIR RESPECTIVE PARTNERS,
OFFICERS, DIRECTORS, EMPLOYEES, SHAREHOLDERS, REPRESENTATIVES OR AGENTS (COLLECTIVELY, "ACCELL")
BE LIABLE FOR DIRECT, SPECIAL, INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR INDIRECT DAMAGES (INCLUDING
BUT NOT LIMITED TO, LOSS OF DATA, USE OR PROFITS), HOWEVER CAUSED, WHETHER FOR BREACH OF
CONTRACT, NEGLIGENCE, OR OTHERWISE, AND WHETHER OR NOT ACCELL HAS BEEN ADVISED OF THE POSSIBILITY
OF ANY SUCH DAMAGES. YOU AGREE THAT ACCELL'S MAXIMUM LIABILITY ARISING FROM ANY PRODUCT SOLD BY
ACCELL SHALL NOT EXCEED THE PRICE OF SUCH PRODUCT. SOME JURISDICTIONS DO NOT ALLOW THE LIMITATION
OF EXCLUSION OF LIABILITY FOR CERTAIN DAMAGES, SO THE ABOVE MAY NOT APPLY TO YOU TO THE EXTENT SUCH
JURISDICTION'S LAW IS APPLICABLE TO THIS AGREEMENT.
Warranty Returns Procedure.
To return an item under warranty, contact Customer Support by E-mail at [email protected] or call 510-438-
9288 to obtain a Return Authorization (RMA) number. RMA numbers are valid for 30 days from the date of issuance.
We are unable to accept returns without an RMA number. Returns without an Accell issued RMA number clearly
printed on the outside of the package will be returned unopened. All returns must be shipped prepaid at the expense
of the shipper. All returns must include a copy of the dated sales receipt.
The information above is believed to be accurate, however Accell assumes no responsibility for any inaccuracies and liability for direct, indirect, special,
incidental, or consequential damages as a result. Due to ongoing improvements, Accell reserves the right to make changes to hardware, packaging and
any documentation without prior written notice.
© 2008 Accell Corporation, All Rights Reserved. Accell and UltraRun are registered trademarks of Accell Corporation. Part #B084C-0506
UltraRun™ 1.3 HDMI Cable Instructions
Includes:
• UltraRun 1.3 Cable with repeater
module
• Power adapter
• Instruction manual with warranty