Bodum BISTRO Мельница и фиксатор для блендера "BISTRO" - Manual (Page 4)

Instruct
Ion for
use
3
– Release the button and unplug the cord from the wall
outlet to isolate the appliance.
– When unplugging the cord from the wall outlet always
grasp the plug, not the cord.
– Do not let the cord hang over the edge of the table or
counter or touch hot surfaces.
– Do not let the cord contact hot surface, including the
stove.
– Keep hands and utensils out of the container while blend-
ing to prevent the possibility of serve injury to persons or
damage to the unit. A scraper may be used but must be
used only when the unit is not running.
– Unplug the cord from the wall outlet when not using the
blender or before attaching or removing parts or cleaning it.
– Do not operate any appliance with a damaged cord or
plug, or after the appliance malfunctions or has been
damaged in any way. Instead, take it to the nearest
authorised service centre for examination, repair or
adjustment.
– Never attempt to replace the cord, as special tools are
required. Repairs to or replacements of the cord should
be left to a service centre authorised by the manufacturer
to ensure the safety of the appliance.
– Never immerse the cord, motor unit or plug in water
or other liquid, as this could cause fire, electric shock or
injury.
– The appliance must remain disconnected from the mains
while it is being cleaned.
– Do not touch any rotating parts.
– To avoid splashing, use a tall container or reduce the
quantity when blending liquids, especially if they are hot.
– Keep hair, fingers and utensils away from rotating parts
to avoid serious injury to persons and damage to the
appliance.
– The blades are sharp: handle them with care.
–
Switch off the appliance and disconnect from supply
before changing accessories or approaching parts that
move in use.
– Beware of potential injury from misuse. Care shall be
taken when handling the sharp cutting blades, emptying
the bowl and during cleaning.
– Never operate the appliance with damaged accessories.
Check for any damage every time before and after use.
– Handle the accessories with care. Never use bare hands to
install and/or remove the accessories. The sharp edges of
the accessories can cause injury.
– check the mill for presence of foreign objects before
using.
– Be certain cover is securely locked in place before operating
appliance.