Bosch Remote Keypad - Manual (Page 22)

22 en FMR-5000-C
F.01U.258.926 | 3.0 | 2012.09 Bosch Sicherheitssysteme GmbH
Functional Description
The Remote Keypad can be used to perform the same operating procedures as the control
panel, enabling variable operation of a networked system. It has the following functional
elements (see Figure 1, Page 4):
Installation
Follow the mounting instructions according to the mouting variant for your application.

Before mounting the housing, remove the operating unit. This prevents the touch screen
being damaged and facilitates installing the lower mounting screws.
Wiring
 Connect the shield wires to the screw terminal (Figure 11, Page 13 (step 1).
 Fasten the cables with cable ties (Figure 11, Page 13, step 1 to 4).
The Remote Keypad has
-
2 CAN interfaces (CAN1/CAN2) for networking
- 2 Ethernet interfaces (ETH1/ETH2) for networking
- 2 signal inputs (IN1/IN2)
- 1 USB and 1 RS232 interface
Consider the maximum cable length of 2 m when using the USB and RS232 interfaces (see
Figure 10, Page 12).
WARNING!
Live components and stripped cable! Risk of injury from electric shock. The system must be
current-free during connection work.
NOTICE!
Installation must only be performed by authorized and specialized personnel!
Pos. Designation Function
A Touch screen Operating the networked system through virtual buttons and variable display windows
B 22 fixed buttons Standard entries
C 11 LEDs Indicating the operating status
D Key switch 2 switch settings, freely programmable, e.g. for switching between day/night mode or
connecting/disconnecting for local alarm signaling
E Reboot button Remote Keypad HW reset
F 6-pin DIP switch Configuration
G 3 rotary switches Address setting
Mounting variants Illustration Mounting Instructions
Surface wall mounting See Figure 2, Page 5, I See Figure 3, Page 6 to Figure 5, Page 8 (step 1 to 13) and
Figure 6, Page 9
Flush wall mounting See Figure 2, Page 5, II See Figure 3, Page 6 to Figure 5, Page 8 (step 1 to 13) and
Figure 7, Page 10
Tilted installation See Figure 2, Page 5, III See Figure 3, Page 6 to Figure 5, Page 8 (step 1 to 13) and
Figure 8, Page 11
NOTICE!
You will find detailed information about the CAN and Ethernet networking of the fire panels in
the Networking Guide available for download at www.boschsecurity.com.