Candy CVM6629PW - Manual (Page 7)

06 GB
Mains power to the electric heaters is controlled by the timer. A
correct timer position should be selected before using the oven.
The timer guarantees that the oven will remain switched on for the
time required. You can adjust the timer up to 90 minutes.
If the use of the timer is not required and you do not want to
programme cooking time, turn timer knob to the “ ” position.
Some electric ovens have a timer which must be set at the time at
which cooking must stop. This control allows for the desired
cooking time to be programmed. The oven will automatically
switch off at the end of the set time.
The timer will count down from the set time, return to the “ O ”
position, and switch off automatically. For normal use of the oven,
set the timer to the “ O ” position and it will switch off automatically.
It can then be used by manual control.
To programme cooking time for the gas oven, turn dial round
completely, and then turn it back to the required time. When the
time has elapsed, the signal will ring for a few seconds.
USING THE MINUTE TIMER
USING THE END OF COOKING TIMER
USE OF THE ELECTRONIC PROGRAMMER
WARNING : the first operation to carry out after the oven has been installed or following the interruption of power supply
(this is recognizable the display pulsating and showing ) is setting the correct time. This is achieved as follows
• Press and hold the TIMER and END buttons ( and )
• Set time with buttons
• Release all buttons
ATTENTION the oven only operates if set on manual function or preset time.
N.B.: on some models the symbols are replaced by + and - .
• Sounds an alarm at the end of the set time.
• To check how long is left to run press the
button
FUNCTION HOW TO ACTIVA HOW TO SWITCH IT OFF WHAT IT DOES WHAT IT IS FOR
MINUTE MINDER •Allows to use the oven as alarm clock (could be activated either with operating the oven
or with out operating the oven)
•Press and hold the button
•Press the buttons or
to set the required time
•Release all the buttons
•For cooking the desired recipes MANUAL
FUNCTION
•Turn the oven function
selector to position“O”
•Enables you to operate the oven.
COOKING
TIME
•At the end of the cooking set time, the oven will switch off automatically and an audible
alarm will ring.
•When the time is elapsed the
oven will switch off
automatically. Should you
wish to stop cooking earlier
either turn the function
selector to 0, or set time to
0:00(TIMER and buttons)
•It allows to preset the cooking time required
for the recipe chosen.
•To check how long is left to run press the
TIMER button.
•To alter/change the preset time press TIMER
and buttons
END OF
COOKING
•This function is typically used with “cooking time” function. For example if the dish has to
be cooked for 45 minutes and needs to be ready by 12:30, simply select the required
function, set the cooking time to 45 minutes and the end of cooking time to 12:30.
•Cooking will start automa-tically at 11:45 (12:30 minus 45 mins) and will continue until the
preset end of cooking time, when the oven will switch itself off automatically
WARNING!
If the END of cooking is Selected without setting the length of cooking time, the oven will
start cooking Immediately and it will Stop at the END of cooking time set. •At the time set, the oven will
switch off. To switch off
manually, turn the oven
function selector to position
“O”.
•Enables you to set the end of cooking time
•To check the preset time press the END button
•To modify the preset time press buttons
END+
•Press and hold the TIMER
button
•Press the buttons or to
set the lenght of cooking
required
•Release all buttons
•Set the cooking function with
the oven function selector
•Press the button
•Set the cooking function with
the oven function selector
•Press and hold the END
button
•Press the buttons to
set the time at which you
wish the oven to switch off
•Release the buttons
•Set the cooking function with
the oven function selector
Setting the correct time:
•When the set time as
elapsed an audible alarm
is activated (this alarm will
stop on its own, however
it can be stopped
immediately by pressing
the button)