Setting up + installation – Candy GO4W464-80 User Manual

Page 18

Note: we recommend you keep the screws to
immobilise the machine for future transit.
The Manufacturers will not be responsible for any
possible damage to the machine caused by not
following the rules relating to releasing the mechanism.
The user is responsible for all costs of installation.

Water connection

The appliance must be connected to the water mains using new
hose-sets.
The old hose-sets should not be re-used.
The machine has an inlet hose with 3/4" B.S.P threaded end
connection to attach between the threaded connector on the
appliance and the cold water supply.

This machine only uses cold water, therefore
only one hose is needed to connect to the cold
water supply. Do not connect to the hot supply.
Cold fill is an energy efficient system. Only the
water required for the washing is heated.There
is no loss of heat in the pipeline from a hot
water tank or boiler to the machine.

min 50 cm
max 85 cm

+2,6 mt max

max 100 cm

min 4 cm

SETTING UP + INSTALLATION

Remove the polystyrene base and place the machine near
its permanent position (diagram 1).

Carefully cut through the hose retaining clip at the rear of
the appliance (diagram 2).

Remove the 3 fixing screws marked (A) and remove the 3
spacers marked (B) (diagram 3).

Remove the screw (C).
A spacer will fall inside the machine.
By tilting the machine, remove the above mentioned spacer.

Cover the 4 holes using the caps provided in the instruction
booklet pack (diagram 4).

WARNING:
DO NOT LEAVE THE PACKAGING WITHIN REACH OF CHILDREN AS IT IS A POTENTIAL
SOURCE OF DANGER.

Apply the insulation sheet of corrugated material to the base
as shown.

Use the 4 feet to level the machine with the floor:
a) Turn the nut clockwise to release the screw adjuster on the foot.
b) Rotate the foot to raise or lower it until it stands firmly on the
ground.
c) Lock the foot in position by turning the nut
anti-clockwise until it comes up against the bottom of the machine.