Candy PSA 640__1 FGH - Manual (Page 7)

2 6
INSTALLATION: "BUILDING-IN"
BUILDING-IN : both the unit into which the hob will be fitted and any adjacent kitchen
furniture must be made of heat resistant material and fixed with heat resistant adhesive.
If, when installing the hob, the lower part of the casing is adjacent to an area normally
accessible when handling or cleaning, fit a partition 1 cm below the base of the casing to avoid
any risk of burning or damage.
There should also be a 5 cm gap between the appliance and all adjacent vertical surfaces.
A foam adhesive is supplied with the hob. Stick this seal under the edge of the body as near
as possible to the outer edge of the hob. Press round the edges of the hob, so that the seal
flattens out and ensures an air tight seal.
Warning : at the rear of the appliance, take care not to choke the air outlets necessary to
the combustion.
FITTING THE SEAL
• Top view of the seal
• C ross section of the hob
W o r k t o p level
6 mm
seal
- Take care not to choke the air outlets
necessary to the combustion -
SEAL